Specs Form : Stereo integrated amplifier Succession effective output : 50W+50W (8 ohms, both channel simultaneous operation) , 60W/60W (8 ohms, one-side-channel operation) THD : 0.03% or less (8ohm, 50W) Cross modulation distortion : 0.04% or less (8ohm, 50W, 70Hz:7kHz=4:1) Output bandwidth : 5Hz - 50kHz three dB (0.1%) Input sensitivity/impedance : 580mV / 50kohm Remains noise : 0.5 mV or less Dumping factor : 40 (8 ohms, 20Hz - 20kHz) Attachment : Attenuator (-18dB) , Main speaker switchpoint , Remote speaker switchpoint , Headset jack Standard output voltage : Pre out 580mV , Rec out 100mV Maximum output voltage : Pre out 5V Output load impedance : Pre out About 100ohms , Rec out About 100ohms Frequency characteristic : 10Hz - 50kHz one dB (Aux1) THD : 0.04% or less (Aux1, 1kHz, 1V) Input sensitivity : Phono1, 2 = 2.4 mV , Tuner 100mV (with an input level set) , Aux1, 2 = 100mV , Mic 2.4mV Input impedance Phono1 : 50kohm, 65kohm, 90kohm, a switching Input impedance Phono2 : 65kohm Input impedance : Tuner = 50kohm , Aux1, 2 = 50kohm , Mic = 50kohm SN ratio : Phono1, 2 = 65dB or more , Mic = 60dB or more , Tuner and Aux1, 2 = 80dB or more Maximum permissible input Phono : 300mV (1kHz, R-M-S) Tone control : With a curving [ LUX scheme NF type ] point switching Tone control : The point curving [ low-pass ]: 150Hz, 300Hz, 600Hz Tone control : The point curving [ high region ]: 1.5kHz, 3kHz, 6kHz Filter : A low cut = 30Hz, 6dB / oct , A high cut = 8kHz, 6dB / oct A low boost : 70Hz Attachment : Tapes monitor switchpoint (two lines) , Dumping switchpoint , Input-impedance switching , Input level set Power consumption : 200W (at the time of an 8-ohm simultaneous load intensity and the maximum output) Dimensions (WxHxD) : 450 x 160 x 268 mm Weight : 11 kg