Specs Form : Solid-state Integrated Amplifier Stereo effective output (both channel drive) : 25 W + 25 W (+/- 1 dB) Effective output : 30 W / 30 W (+/- 1 dB) Music power : 70 W (+/- 1 dB) THD : 0.5 % or less Cross modulation distortion (60 Hz : 7 kHz = 4:1) : 0.8 % Power Band Width (IHF, 0.5% of distortion) : 20 Hz - 50 kHz Frequency characteristic : 20 Hz - 100 kHz (+/- 1dB) (at the time of a normal output) Channel separation : 50 dB A hum and a noise (IHF, closed circuit) : 100 dB Input sensitivity (an effective output, 1kHz) : 1 V Input impedance : 300 kohm Load impedance : 8 ohm - 16 ohm Damping factor : 24 (8 ohms)
Center channel output Flat output : 9.5 V High cut output : 1 V (fo = 200 Hz) Presence : 50 Hz, +6 dB (fo = 125 Hz)
Preamplifier part Maxima : 5 V Rate : 1 V (180 ohms) THD : 0.1% (Output-power voltage) Frequency characteristic : 20 Hz - 70 kHz +0.5 dB to -1.5 dB A hum and a noise (IHF) Phono1, 2 : 80 dB (closed circuit) Tape Head 19 cm/sec : 85 dB (closed circuit) AUX1, 2 : 85 dB (open circuit) Input sensitivity / impedance (1kHz) Phono1 : 2 mV / 47 kohm Phono 2 : 2 mV / 100 kohm Tape Head 19 cm/sec : 1.5 mV / 200 kohm Tape Head 9.5 cm/sec : 1.3 mV / 200 kohm AUX1, 2, Tape Monitor : 140 mV /, 100 kohm Sound-recording output (Tape Rec) Phono1, 2 : It is 37 dB (70 times) to an input. Tape Head 19 cm / sec : It is 39 dB (90 times) to an input. Tape Head 9.5 cm / sec : It is 41 dB (110 times) to an input. Tone control Bass : 20 Hz +/- 15 dB (3 dB step) Treble : 20 kHz +/- 15 dB (3 dB step) Loudness control (Volume -30 dB) 50Hz : +8 dB, 10 kHz : +5 dB A high filter : 20 kHz - 22 dB A low filter : 20 Hz - 21 dB Muting : - 20 dB (20 Hz - 20 kHz) Mode switch Stereo (Norm, RX-Net Rev) Mono (L, R) Supply voltage : AC 220 V , 50 Hz / 60 Hz Power consumption Maxima : 165 VA (AC 240 V, 50 Hz / 60 Hz) Dimensions (WxHxD) : 435 x 155 x 334 mm Weight : 12.3 kg